Finn Goheen

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a little but it's still eye-catching. It's not the most luxurious car in its class, but it's an enjoyable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is ongoing or continuous the following suggestions should assist.

Water Damage

If you leave your fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting, or canyoning, it's likely to sustain water damage. Keep your key fob in a dry, dry bag each time you go outdoors or do things that expose it to a lot of water.

It's also important to make sure that the fob is completely dried out before you open it and use it again. If you detect any smells coming from the fob, like an industrial smell or a sour taste like windshield washer fluid, it's another sign that it's been submerged in water.

A circuit that is wet can cause the battery's energy to drain or even explode. If you're able, if you can, pull the 308 key fob of the water body it was stuck in, flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then wipe the circuit board clean using a cotton swab that has been dipped in 90-percent alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not function could be due to a dead coin-cell battery or receiver module malfunction, signal interference or a damaged chip. If none of the above are the cause, you can reset the system by disconnecting the 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars come with remote start that lets drivers start their vehicle from a distance, allowing them to warm up or cool down the car before entering. This feature is extremely helpful particularly during the cold winter months. The remote start system can be stopped for a variety of reasons, such as a dead coin-battery.

A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often utilized and where it was purchased. The date for use-by will be displayed on the packaging or mentioned in the user's manual.

If the key fob stops working after being exposed to clean tapwater, take out the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. If you expose it to salty or soapy water, the chip may be damaged and you'll have to replace the key fob in total.

If you are not sure the battery is defective, you can test the voltage with a multimeter set to the vehicle's voltage range and connected to the plus and minus terminals. The voltage should read approximately 12 to 13 volts, but if it is lower, the battery should be replaced. If you want to, you can try to reset the on-board computer by disconnecting the battery with 12 volts for a short period of time, and reconnecting it in reverse order (positive cable first and then negative). The engine should then start after this.

Faulty Receiver Module

If you don't see the "Key Detected" message, it could mean that your receiver module is not working properly. It's the component that sends out a signal when your key fob activates. It also acts as an alarm and prevents the vehicle from starting without the correct key.

It could be due to many factors, including water damage or just the aging process. If the electronic chip within your peugeot partner replacement key 308 keyfob is damaged by dirty tap water it could be due to the fact that the keyfob was in contact with it. In this situation, you'll need to take it out and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the issue continues to persist, it is a good idea to visit a local Peugeot expert or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.

Losing your Peugeot keys to your car can be an extremely stressful experience. A certified auto locksmith will be able to solve the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, ensuring you're ready to get on the road again in the shortest time possible. Click here to find a local locksmith near you.

Electronic chip malfunctions

The chip inside your Peugeot 308 key fob is an crucial component of the remote control system. If it gets damaged, your car may not start or you might receive a message that reads "anti-theft active". In this scenario the only option is to replace the key. Auto locksmiths who are professionals are able to provide the fastest possible time.

The chip inside your Peugeot 308 key fob can be damaged due to water damage, sweat, dirt or other reasons. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery must then be allowed to dry completely.

Sometimes the key fob may cease to function due to radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects in the vicinity of the vehicle. If you encounter this issue it is advised to visit the Peugeot dealership.

The peugeot 406 key fob 207/308 key fob is extremely delicate and requires extra care. It is not recommended to drop it or throw it around. If you lose it, try to find it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.