Shellie Fishbourne

Peugeot 208 Key Replacement

Peugeot 2008 Replacement Key Cost 208 key replacement is best left to auto locksmiths with experience who have the proper equipment and technical know-how much is a new peugeot key. They can create and program keys faster and less expensive than dealers.

If the key fob has stopped locking or unlocking your doors, it is likely due to a dead battery in the coin. There are other reasons that the key might be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as hindering it from starting the engine. If this is the situation, you'll need make use of the backup starting procedure that's described in the owner's manual of your vehicle.

Another reason your 208 might not start is that the spark plugs have been damaged. The spark plugs are responsible to ignite the fuel which starts the engine. However, they have a limited life span. If they are not used enough, they will eventually fail.

Fortunately, there's an easy solution for this issue. The best solution is to measure the voltage of your car battery using a multimeter. If the voltage is lower than 11,5 volts, then it's time to replace it. If the battery has corrosion it is crucial to clean its contacts. This can be done by lifting the rubber covers that cover the two battery terminals and using a wire brush to remove any corroded components of the battery. Then, you must reconnect the positive pole cables to the negative.

Water Damage

If your 208 doesn't start and the battery hasn't fallen flat, it is time to inspect the spark plugs. It could be that they are filthy and don't spark. The spark plugs can be cleaned in the workshop.

Peugeot automobiles use a key with a transponder compatible with the immobiliser. This makes sure that only the correct key is able to turn the engine. If the chip inside the Peugeot key is damaged, it won't transmit the correct signal to the vehicle.

This is a common problem that can be caused by water damage. This is a frequent issue in areas with colder temperatures where the vehicle is exposed to snow or rain. In this situation, contact a trusted locksmith who has the required tools and equipment to change the key's programming. They will also have the most up-to-date technological know-how and the equipment required to create a peugeot 207 new key programming 208 smart key. The process should take no more than 15 minutes.

Contacts of the battery may be damaged.

Peugeot changed from the carbon-encased transponder chips to a new type of chip that uses electronic components that are placed on circuit boards. This new technology works great when it's new, however, over time, the circuit boards start to wear out and stop functioning correctly.

This can prevent the immobiliser chip from working and causing your car to not start. If this happens, it's a good idea contact a Peugeot specialist or locksmith.

Another common issue is when the battery in the key fob starts to die, this causes the blade of the key to stop being able to feed into the lock. A locksmith from your car will replace the battery, and then cut a fresh blade for you. This is a quick solution.

Faulty Receiver Module

If your Peugeot key fob has stopped working after dropping it on the floor, getting exposed to a sudden downpour or accidently washing it the wrong way, it could be due a malfunctioning receiver module. The receiver is responsible for transmitting radio frequency signals to the on-board computer, which is responsible for controlling the centralized locking system in your Peugeot vehicle.

The key fob itself is fitted with rubber seals that block water from getting to the electronic chip inside. However, prolonged exposure to water could break through these seals, causing damage to the chip. The high salt content of the ocean water or pool can cause damage to the key fob when it is submerged.

If your Peugeot spare key fob isn't working, you'll need to have the module replaced. This should be done by an Peugeot specialist or a professional auto locksmith. Unlike other cars, Peugeot keys are protected by an immobilizer that is unique and requires the right coding for the start of the engine. It is for this reason that you should only rely on the Peugeot locksmith to create and program the replacement.

Computer malfunctioning on-board

The on-board computer in your peugeot 308 key replacement is responsible for a variety of functions in your car including power windows and airbags. The on-board computer will display an error code when something goes wrong. This code is saved in the system and stays there until the issue is fixed. Often, this will involve replacing the on-board computer.

One of the most frequent causes of the light flashing is loose or corroded connections within the airbag sensor. It can be due to wear and tear, aging or exposure to salt and moisture. It is essential to have this issue resolved as soon as possible, as the airbag malfunctioning could be dangerous in the event an accident.

If you notice a card not found error on your Peugeot, the key battery in the key fob may be weak or dead. This will stop the key fob sending a signal to disarm the immobilizer in your vehicle. You can test this by pressing the unlock button on the key fob and then trying to start your car. If it doesn't work then the battery in the key fob is in need of replacement.